<< Click to Display Table of Contents >> Raynet One Data Hub > 2026.4 > Connectors > Alphabetic Connector List > Databricks  Connector Setup

To set up the Databricks connector in Data Hub, perform the following steps:

 

1.Obtain the Delta Sharing credential profile from your Databricks administrator. Extract the bearer token and the endpoint URL from the profile.

2.In Data Hub, create a new task using the Databricks connector.

3.Enter the Bearer Token into the corresponding field. Enter only the token value, without a Bearer prefix and without the surrounding credential profile JSON.

4.Enter the Delta Sharing Endpoint URL into the corresponding field. Enter only the endpoint URL, not the full credential profile JSON. The URL must use HTTPS and must not contain embedded credentials, query parameters, or a fragment.

5.Save the task configuration and run the task to verify connectivity and data collection.

 

The connector automatically discovers the required shared tables from the configured endpoint. No manual table selection is required.